Using PowerPro
Spooling Up
Unlike monofilament, PowerPro will not stretch on the reel and cling to the barrel. This can result in line sliding around the barrel, which can seem like a problem with your drag mechanism. Rest assured, your equipment is fine. To avoid slippage, attach PowerPro to your spool using one of these methods:
If your reel has a hole or knob on the barrel, use it.
Leave at least 5 to 10 yards of monofilament on the reel (enough to cover the bottom of the spool) before attaching PowerPro with a Uni to Uni splice.
Put a piece of compressible tape on the barrel before attaching PowerPro.
Setting the Hook
Anglers on Saturday morning TV shows often set the hook in bass like Samurai warriors beheading the enemy. This may be a fine technique with monofilament line, but PowerPro doesn't require such a violent motion. When you get a strike, relax; a gentle snap of your wrist will set the hook. Because PowerPro doesn't stretch like nylon lines, you won't get that rubber-band effect. Every inch you move your rod tip equals an inch of movement at the lure.
Setting your drag
PowerPro lines are so small for their strength that you may be tempted to set your drag higher than normal, but remember, your rod or reel may not be designed to handle the same unbelievable loads as your line. To make full use of PowerPro's amazing sensitivity without risking damage to your equipment, try one of the following tips:
At lower drag settings, a little extra line may pay out at the hookset, compensating for PowerPro's lack of stretch.
Fish with Spinning Reels
For optimal PowerPro performance on your spinning reel, we recommend closing the bail manually. While your bait is falling, pull on the line to make sure it is seated firmly on the reel, then begin your retrieve.
Cutting PowerPro
PowerPro is extremely strong, and nail clippers won't cut it. We recommend sharp scissors such as Fiskars for kids, which are inexpensive, easy to find, and have blunt ends to protect your pockets.
Coloring PowerPro
Spectra Fiber is an especially dense material that cannot be permanently dyed. The color simply encapsulates the line and will wear away with time. This is normal and does not affect the strength or performance of the line. To re-color your PowerPro line, simply use a permanent magic marker in whatever shade you prefer.
Retie your line
Although PowerPro is extremely strong, it isn't indestructible. If the line starts to look frayed, especially after fishing around structure, it's probably time to cut off the worn section and retie. This way your line will always perform at rated strength.
Repack your line
If your line starts to feel soft or mushy on the reel, especially when fishing with light baits, you should repack your reel. Make an extra long cast or let the line out behind your boat, then reel it in while holding the line taut with your fingers. This will improve casting performance and keep the line from "digging in" after a solid strike.
Using a Monofilament Leader
Attaching a monofilament leader to your PowerPro line may prove useful in the following situations:
When bait or jig fishing requires extra finesse, especially in clear water, use a 3-foot monofilament leader to cut down on line visibility.
When fishing for species that strike hard and fast, use a monofilament shock tippet. For close-in situations such as bait fishing, try a 3- to 10-foot tippet. For big game applications, you may want to use up to 100 yards or more.
CAUTION
PowerPro is remarkably thin and strong. To avoid injury, never wrap it around your fingers or hands. If you need to break off the line, wrap it around a solid object and pull
Unlike monofilament, PowerPro will not stretch on the reel and cling to the barrel. This can result in line sliding around the barrel, which can seem like a problem with your drag mechanism. Rest assured, your equipment is fine. To avoid slippage, attach PowerPro to your spool using one of these methods:
If your reel has a hole or knob on the barrel, use it.
Leave at least 5 to 10 yards of monofilament on the reel (enough to cover the bottom of the spool) before attaching PowerPro with a Uni to Uni splice.
Put a piece of compressible tape on the barrel before attaching PowerPro.
Setting the Hook
Anglers on Saturday morning TV shows often set the hook in bass like Samurai warriors beheading the enemy. This may be a fine technique with monofilament line, but PowerPro doesn't require such a violent motion. When you get a strike, relax; a gentle snap of your wrist will set the hook. Because PowerPro doesn't stretch like nylon lines, you won't get that rubber-band effect. Every inch you move your rod tip equals an inch of movement at the lure.
Setting your drag
PowerPro lines are so small for their strength that you may be tempted to set your drag higher than normal, but remember, your rod or reel may not be designed to handle the same unbelievable loads as your line. To make full use of PowerPro's amazing sensitivity without risking damage to your equipment, try one of the following tips:
- Set your drag to match the weakest component in your tackle system.
- Set your drag to match the size of mono line you would normally use.
- When using ultralight equipment or line (10- or 20-lb. test) set your drag to no more than 1/3 of the line's rated strength. You can check the drag with a fish scale.
At lower drag settings, a little extra line may pay out at the hookset, compensating for PowerPro's lack of stretch.
Fish with Spinning Reels
For optimal PowerPro performance on your spinning reel, we recommend closing the bail manually. While your bait is falling, pull on the line to make sure it is seated firmly on the reel, then begin your retrieve.
Cutting PowerPro
PowerPro is extremely strong, and nail clippers won't cut it. We recommend sharp scissors such as Fiskars for kids, which are inexpensive, easy to find, and have blunt ends to protect your pockets.
Coloring PowerPro
Spectra Fiber is an especially dense material that cannot be permanently dyed. The color simply encapsulates the line and will wear away with time. This is normal and does not affect the strength or performance of the line. To re-color your PowerPro line, simply use a permanent magic marker in whatever shade you prefer.
Retie your line
Although PowerPro is extremely strong, it isn't indestructible. If the line starts to look frayed, especially after fishing around structure, it's probably time to cut off the worn section and retie. This way your line will always perform at rated strength.
Repack your line
If your line starts to feel soft or mushy on the reel, especially when fishing with light baits, you should repack your reel. Make an extra long cast or let the line out behind your boat, then reel it in while holding the line taut with your fingers. This will improve casting performance and keep the line from "digging in" after a solid strike.
Using a Monofilament Leader
Attaching a monofilament leader to your PowerPro line may prove useful in the following situations:
When bait or jig fishing requires extra finesse, especially in clear water, use a 3-foot monofilament leader to cut down on line visibility.
When fishing for species that strike hard and fast, use a monofilament shock tippet. For close-in situations such as bait fishing, try a 3- to 10-foot tippet. For big game applications, you may want to use up to 100 yards or more.
CAUTION
PowerPro is remarkably thin and strong. To avoid injury, never wrap it around your fingers or hands. If you need to break off the line, wrap it around a solid object and pull